Page 1 of 1
in Macro
Posted: Mon Jan 05, 2009 11:02 am
by saschech@gmx.de
Hallo together
My problem:
"in macro" read in flowcode simulation 00
on my bord:
"in macro" read in flowcode simulation ff
so i have a big problem to simulate,because alltime i must changing the value of my read.
Is there a way to changing the read value only in flowcode simulation?
Regards wolfgang
Re: in Macro
Posted: Mon Jan 05, 2009 5:56 pm
by Sean
Hello Wolfgang,
You can set the values read by simulated inputs by adding switch components to your flowchart and configuring the connection settings for the correct ports and pins. In the switch properties, set the 'Switch Type' to 'Toggle'. This will allow any input pattern to be set permanently.
The switch setting can be read directly by the "in_macro" (you do not need to use switch component functions to read the values).
Re: in Macro
Posted: Mon Jan 12, 2009 11:53 am
by saschech@gmx.de
Hallo Sean
The tip work but if i send data to the port,in simulate mode the led`s connect to the port have a other reaction.
regards wolfgang
Re: in Macro
Posted: Mon Jan 12, 2009 1:02 pm
by Benj
Hello Wolfgang
If you are outputting values on the ports then the LEDs will not behaive the same as the switches in simulation and on hardware. This is because the LED resistors are much smaller then the switch resistors allowing the LEDs to reflect the I/O pin status rather then the switch status. You can use the masking option if you need to leave pins as inputs when performing output writes etc.