Matrix user forums

Hello,
What is the most efficient means of setting/resetting a flag (i.e. pushbutton pressed, event occurred, etc.) in flowcode?
Thanks,
Mike

Hi,

I am not sure but check out this post, I think I asked same question some time ago in a slightly different way.

http://www.matrixmultimedia.com/mmforum ... f=5&t=4209

Ron

Hello

If you want to keep it simple then you can simply use a input icon to read a single pin. Then use a decision box and simply put the variable name into the decision icon.
Then if the variable is anything other then 0 your decision will equal yes. This will also act to clear the flag because the input variable is refreshed by the input icon every time around the loop.

Hi Benj and Ron,

Thanks to both of you gentlemen for the help.

Best Regards,

Mike