Page 1 of 1
Pull up
Posted: Wed May 19, 2010 1:05 pm
by Frank123
Hi,
I have pull-up on my C port. When i want to simul, default read is "0". Is it possible to change this. If not, could you add this in future version.
Thanx
Re: Pull up
Posted: Thu May 20, 2010 8:42 am
by Benj
Hello Frank,
You could always add a single switch or switch bank to the port you wish to simulate the pullup on. Next change the switch type property to toggle and then start the simulation and set the switch. Your pull up will now be simulated correctly.
Re: Pull up
Posted: Thu May 20, 2010 9:23 am
by Frank123
Thank's
Re: Pull up
Posted: Mon May 24, 2010 11:38 am
by Frank123
You could always add a single switch or switch bank to the port you wish to simulate the pullup on. Next change the switch type property to toggle and then start the simulation and set the switch. Your pull up will now be simulated correctly.
No, my switches are in a keyboard, so I need to change the state of lines and columns and having a pull-up or pull down on the rows or columns.