Matrix user forums

Hi

How can I control a servo motor?
I am using the ECIO-40, and PWM, I have reduced the PWM frequency to a minimum, but nothing is happening!
I also tried turning on a pin for a few milli seconds, but it is only turning a few degrees and then stops.

What can I do?

Thanks

Hi kirstom14,

Have you checked out Sean's article on servos? There is some good information there and an example Flowcode file you can look at to try and help you understand!

http://www.matrixmultimedia.com/mmforum ... =26&t=4799

Regards,

David