Matrix user forums

I am a flowcode V4 user, but cannot post it there for some reason ( too new member??).

I want to read the temperature from a MAX6675 with SPI into a ECIO28, but the issue SPI is all about E-blocks
ECIO :::::::: MAX
A1 clock ser.
A2 ser. data out
A3 non chip select

I hope next time to be able to post at V4 and i am sure you can help me.

thank you.

Jan Bardoel wrote:I am a flowcode V4 user, but cannot post it there for some reason ( too new member??).

Welcome to the forums.
You need to run your copy of flowcodeV4, then select 'Help' 'Online resources'. That will take you to a web site in which you need to enter your Username
and Email. You would be able to post on V4 section when those details are processed by Matrix staff.

I did but was not able to post.
the email addres must be the same as to subscribe to the forum or i did use the software ??
I will try both.
thanks.