Matrix user forums

Hi,

I'm new to flowcode and I looking for help with the internet e-block board. I am trying to use the precompiler test program EB023_test.hex. I have complied this using a universal ic device as I can see where using flowcode I can down load a hex file. When I boot up the 006 board to run the file the lcd does not show anything. The lcd is working as I have downloaded a timer to the lcd. I have followed the datasheet to the letter but the test procedure is where it all goes wrong. I'm using the 16f877a pic.

Can someone please help me here as this is the start of a final year project.
Thanks in advance
MC

I finally made some progress with this. After discovering the ip address of both cards and using a common gateway, I was able to send a UDP request that displayed a message on the lcd. There was alot of trial and error before finally made some progress. Next step now is to send the position of a joystick control attached to one USB multiprogrammer via the internet board to control a servo motor on the opposite end also attached to a usb programmer. If anyone has any input on how I can achieve this I would be glad to here it.

Happy New Year to All
MC