Matrix user forums

Hello

I'm working on a project where i'm trying to get a small webserver running on the internet board and the multiprogrammer from avr.

i have been trying for weeks and searched all forum for more information.
i have the ATMega324p
i know that the patch is to link the SDA to C1, SCL to C0 and the INT to D2-D3 or B2
but no programs worked whit this patch

already thanks

Hello,

The E-block should be connected to the ATmega324P like this.

Connected the E-block to Port C.

In the properties of the TCP or Webserver component set the I2C interrupt to 2.

Connect the 3 way jumper to J3 and use small lengths of single core wire to connect across the signals as shown below.

SCL - Pin 0
SDA - Pin 1
INT - Pin 2