servo driving

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
User avatar
achillis1
Posts: 347
Joined: Thu Oct 09, 2008 9:19 am
Has thanked: 91 times
Been thanked: 8 times

servo driving

Post by achillis1 »

Hello,

HAs anyone got a flowcode routine that actually works with a servo, either 60 degrees or 180 degrees servo?

Thank you,

Andreas Achilleos
Top
User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:
Contact Benj

Re: servo driving

Post by Benj »

Hello Andreas,

Are you using v3 or v4 of Flowcode? I have used servo motors with both v3 and v4. v3 using Sean's servo article and v4 using the servo component.

Here is Sean's v3 article.
http://www.matrixmultimedia.com/mmforum ... =26&t=4799
Top
User avatar
achillis1
Posts: 347
Joined: Thu Oct 09, 2008 9:19 am
Has thanked: 91 times
Been thanked: 8 times

Re: servo driving

Post by achillis1 »

Hello Ben ,

I am using V4.
Top
User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:
Contact Benj

Re: servo driving

Post by Benj »

Hello,

Please post your questions in the v4 Flowcode section.

Here is a link to an Article using the v4 component.
http://www.matrixmultimedia.com/article.php?a=361
Top
Post Reply

Return to “General Programming”