Page 1 of 1
Adding configuration settings to FCD files
Posted: Tue Aug 23, 2011 10:36 am
by medelec35
Has the [config] option been disabled with FC4 pic version?
Tried
Code: Select all
[Config]
0=0x3F6A
1=0x3FFF
2=0xFFFF
3=0xFFFF
4=0xFFFF
5=0xFFFF
6=0xFFFF
7=0xFFFF
8=0xFFFF
9=0xFFFF
10=0xFFFF
11=0xFFFF
12=0xFFFF
13=0xFFFF
Below [Device] and config settings remained at the default 0x3FFF value
Thanks
Martin
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 3:31 pm
by Steve
Hi Martin,
Did you also add the "ConfigOverride=1" line in the [Device] section?
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 3:58 pm
by medelec35
Hi Steve welcome back. Hope you had a good break.
Steve wrote:Did you also add the "ConfigOverride=1" line in the [Device] section?
Yes that’s it, did not know I had to add that line
Thank you.
Is there any way to not only to alter config value and save as new default, but also allow the conventional way of altering configuration since
ConfigOverride=1 greys out the configuration option?
Martin
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 4:13 pm
by Steve
Yes - I had a great break, thanks. We drove all the way to Slovenia which is a very beautiful country.
At the moment there is no way to do this. But it should be easy to allow the values in the [Config] section to be the defaults if the "ConfigOverride" is not set. I'll try to push this in to V5.
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 5:59 pm
by jgu1
Hi!
Will you please explain. I don´t understand this. Is it something we have to add in fcd Lib?
Thank´s in advance.
Regard
Jørgen.
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 6:49 pm
by medelec35
jgu1 wrote:Hi!
Will you please explain. I don´t understand this. Is it something we have to add in fcd Lib?
No its nothing you need to add.
When you select a target device to use e.g 16F88, then the default configuration settings are Watchdog timer and Low voltage programming enabled etc.
What I wanted to do was alter FCD file so Watchdog timer and Low voltage programming are both disabled. OSC set to HS etc by default when start a new project.
That's what this was all about.
Nothing to do with any bugs or issues.
@Steve Never been further then south Germany, and that was on company visit
Glad you enjoyed it, sounds very nice. Im jealous.
Martin
Re: Adding configuration settings to FCD files
Posted: Tue Sep 06, 2011 7:07 pm
by jgu1
thank you Martin!
Jørgen
