Component: ADC (MCP356X) (Analog Input)

Author	MatrixTSL
Version	1.0
Category	Analog Input

ADC (MCP356X) component

An external ADC featuring 2, 4, or 8 channel 24-bit input. Capable of reading each channel independently or in differential mode. Communication using an SPI bus up to 20MHz.

Detailed description

No detailed description exists yet for this component

Examples

No additional examples

Downloadable macro reference

	SampleADC
Performs a single ADC sample and returns the result as a 24-bit value
- BYTE	PositiveChannel
0=CH0 - 7=CH7, 8=GND, 9=VDD, 11=REF+, 12=REF-, 13=TP, 14=TM, 15=VCM
- BYTE	NegativeChannel
0=CH0 - 7=CH7, 8=GND, 9=VDD, 11=REF+, 12=REF-, 13=TP, 14=TM, 15=VCM
[[File:]] -	Return

	Initialise
Confgures the SPI bus ready for communications and initialises the MCP356X device. Returns true if device is responding to commands.
- BOOL	Return

Property reference

	Properties
	Device Type
	Device Address
These bits are fixed from the manufacturer and by default are 01. Used as Bits 6 and 7 of the command byte. Alternative bits must be requested from the manufacturer.
	Clock Selection
	Sensor Bias Current
	ADC Bias Current
	AMCLK Prescaler
	Oversampling Ratio
	ADC Gain
	IRQ Mode
	Scope Traces
Selects if the scope traces are automatically generated or not
	Console Data
Selects if the console data is automatically generated or not
	API
Selects the API Slave to use to send and receive real world SPI data during simulation.
	Connections
	Channel
SPI Channel selector
	Prescale
Prescale option selector
	MOSI
SPI Data Out Pin SDO - Also Known as Master Out Slave In (MOSI) when used in Master mode.
	MISO
SPI Data In Pin SDI - Also Known as Master In Slave Out (MISO) when used in Master mode.
	CLK
SPI Clock Pin CLK - The Clock signal is driven by the SPI master.
	CS / SS
Chip Select / Slave Select Pin Master Mode: General purpose output pin used to select the remote SPI device. Slave Mode: Hardware chip select pin input used to select the SPI device.
	Use IRQ
No: Use polling of the status register to determine when an ADC sample is complete. Yes: Use the IRQ interrupt pin to determine when an ADC sample is complete.
	IRQ Pin
Connected to the IRQ pin of the device, goes low on an interrupt event such as sample complete.
	Simulations
	Simulate Comms
No: Simulation is done using panel sliders. Yes: Send SPI data via API interface and show real time data using panel sliders.