Component: Wii Nunchuk (General Input)

Author	Matrix TSL
Version	2.0
Category	General Input

Wii Nunchuk component

A component to interface the Wii Nunchuck which features a 3-axis 10-bit Accelerometer A 2-axis 8-bit joystick and two digital button inputs. Interfaced using a standard I2C bus at 100KHz. Nunchuk must be powered at 3V3 to avoid damage.

Component Pack

FREE

Detailed description

No detailed description exists yet for this component

Examples

No additional examples

Downloadable macro reference

	SimReset1G
Resets the simulation to 0.0 on X and Y and 1.0 on Z as if the accelerometer was sitting completely horizontal.
- VOID	Return

	ReadJoystick
Reads a single joystick axis
- BYTE	Axis
0=X, 1=Y
- INT	Return

	ReadSwitch
Reads one of the nunchuck switches
- BYTE	Switch
0=Z, 1=C
- BOOL	Return

	Sample
Reads from the nunchuck and updates the local variables.
- VOID	Return

	ReadAccelerometer
Reads a single Accelerometer axis
- BYTE	Axis
0=X, 1=Y, 2=Z
- INT	Return

	Initialise
Sets up up the communication bus and initialises the accelerometer module. Returns 1 for success and 0 for fail.
- BYTE	Return

Property reference

	Properties
	Bit Depth
The number of binary bits used to store the sensor's X,Y,Z readings.
	Encryption
Decides if encryption should be active or disabled
	Connections
	Channel
Channel selection
	Baud Select
Baud rate option selector
	Baud Rate
Baud rate to be used
	SDA
Pin used for SDA (data signal)
	SCL
Pin used for SCL (clock signal)
	Stop Delay
On older microcontroller devices there is a potential for the I2C hardware channel to lock up if there is not a 10ms delay between an I2C stop event and the next I2C start event. Most modern microcontrollers will not have a problem so this property can be disabled to speed up the I2C communications.
	Simulation
	Simulate Comms
Yes: Accelerometer data will come from the simulation component sliders. No: Accelerometer data will come from the CAL component - I2C or SPI - API etc