Flowcode Support Board

Ok, sorry about that. Here you are...

And this one works fine in the simulator, but on Arduino the output on Pin 5 stays high

Hello
I have just looked at your Project and the issue is what I have linked to in

medelec35 wrote: ↑

Tue Sep 20, 2022 2:34 pm

Hello.
Also, take a look here and see if it resolves your issue.

Hi, after reading some other posts on this issue I finally got it cracked - it's not very intuitive! Anyway, I'm there now, if I get stuck again I'll post.
Cheers