Potentiometer not acting as analogue input

[Mikeatukstemdotuk]

I have a10k pot with the wiper connected to A0 on an Arduiono R3. Setting a variable to be the value of this input doesn't seem to work. I'm trying o have the Pot control the off period for a flashing LED. When run the LED goes off for either 1s or 0s. Any help please. Thanks

[chipfryer27]

Hi

If you could post your chart we can have a look and perhaps make suggestions.

Regards

[medelec35]

Hello.
Also, take a look here and see if it resolves your issue.

[Mikeatukstemdotuk]

Hi, apologies for delay - I've been away for a while.
(I'm not sure how to post the chart - the add picture function here doesn't work)

Is there support I can email to?

Thanks

[stefan.erni]

Hi Mikeatukstemdotuk

Can you try with drag and drop the picture? And resize the picture if it's large.

regards

Stefan

[Steve-Matrix]

I'm not sure how to post the chart

Click the "full editor & preview" button to reply to this post and click the "add file" button in the "attachments" tab to attach your Flowcode project file.

[Mikeatukstemdotuk]

Hi When I click the 'add image button' I get this:



There is no 'add file' button that I can see

[Steve-Matrix]

It will be here once you have clicked on the button to reply:

2022-10-19 17_12_28-Flowcode Support Board - Post a reply.png (13.35 KiB) Viewed 3079 times

[Mikeatukstemdotuk]

Hiya

See the attachments button now

Two files are there - neither of which works on Arduino although the simulation works fine

[medelec35]

Please, always post your project file that ends with .fcfx as from the images we can't see your component property settings that can have an effect on your hardware.