GPS - Using Mikroe BL0106 Click Adaptor

[gavo4]

Hi All,

I am a newbie to the Flowcode and I tried the Standard GPS Test Program which I modified for the Arm Development kit BL0061-1 and can't seem to get it to work at all.

I also used the RS232/UART Component and tried to receive one character at a time with no success.

Please see attached, can anyone perhaps point me in the right direction please?....

Regards,

Gavin

[gavo4]

Oops meant to add I am trying it with the GNSS Click 5 and the GPS3 Click board as well

[stefan.erni]

Hi Gavo

Can you post a foto from your hardware?
Do you have a drawing or wiring list to the clickboard?

Pin 2 from the Clickboard is reset => set it to hi

Pin 13 RX to Arm TX
PIN 14 TX to Arm RX


regards

Stefan

[gavo4]

Hi Stefan,

Please see attached,

Look at the Consol as well when I simulate it does something very weird.

When I run the GPS Injector in the Simulation is seems to work

How would I pull the reset pin high?

Regards,

Gavin

Clipboard01.jpg (137.26 KiB) Viewed 2207 times

IMG_3525_2.jpg (52.9 KiB) Viewed 2207 times

[stefan.erni]

Hi Gavin


I do this with a "virtual" LED.
From the component output I get a LED (5mm, Panel).
Then I give this LED a name and determine the port in the propertis. If you use the the clickboard on connector D, in your case it would be maybe D7.
You can set the pin with a component macro to TurnOn. For a reset you can use the component macro and set the pin to TurnOff for a short time. The reset pin is active with a low.

regards

Stefan

18-08-2020 10-33-03.png (140.41 KiB) Viewed 2144 times