If you have other devices thats using the mchpusb64.sys or mchpusb.sys
flowcode can run into problems when you presse reset for programming.
Look into devicemanager, under the tab "Custom USB Devices" -
If there is a "Microchip Custom USB device" active you can have the problem.
My device i a Mplab Real ICE programmer, and i have to unplug it to use FlowCode Programmer.
USB Programming WIN7
-
JoakimSoya
- Posts: 6
- Joined: Mon Oct 25, 2010 5:55 pm
- Location: Denmark, Stenløse
- Contact:
-
Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: USB Programming WIN7
Hello,
Yes this is a limitation of the Microchip system file that is responsible for controlling the USB transactions. Unfortunatley there is not a lot we can do about this short of getting Microchip to re-write their system file which I don't really think is going to happen. At least not in the near future.
Yes this is a limitation of the Microchip system file that is responsible for controlling the USB transactions. Unfortunatley there is not a lot we can do about this short of getting Microchip to re-write their system file which I don't really think is going to happen. At least not in the near future.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel