Hi All,
Does someone have experience with the motor driver L298, e.g. used on the EB022 board? I have to minimalise the size of the board and try to combine the smallest microcontroller 12F1840 with this motor driver L298.
In the test phase I tried only the L298 driver, without success. The only result is that one output pin is always 0V and the other +12 Volt. What I'm doing wrong?
Kind regards
Jan Lichtenbelt
Testing L298 motor driver
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
-
misoct
- Posts: 64
- Joined: Sat Sep 04, 2010 11:03 pm
- Location: Egypt
- Has thanked: 8 times
- Been thanked: 17 times
Re: Testing L298 motor driver
Hi Jan Lichtenbelt
I built many of H-Brige to drive DC motor using L298 and they work fine
look at this site
http://www.ikalogic.com/shm_hb_l298.php
Or
http://www.ikalogic.com/H_bridge_1.php
Best Regards
Tharowat
I built many of H-Brige to drive DC motor using L298 and they work fine
look at this site
http://www.ikalogic.com/shm_hb_l298.php
Or
http://www.ikalogic.com/H_bridge_1.php
Best Regards
Tharowat
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
Re: Testing L298 motor driver
Dear Tharowat
Can you send me the PCB file of http://www.ikalogic.com/shm_hb_l298.php
I can not open de HBL298.zip file (do not know why).
Thanks a lot
Jan Lichtenbelt
Can you send me the PCB file of http://www.ikalogic.com/shm_hb_l298.php
I can not open de HBL298.zip file (do not know why).
Thanks a lot
Jan Lichtenbelt