I use one RS232. By some reason I have two RS232 components, which can be seen in the component macro's RS232(0) and RS232(1). In the panel I see only one RS232 picture.
My question is: How can I delete the second RS232 component?
Kind regards
Jan Lichtenbelt
Delete Double Component
Moderator: Benj
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
Re: Delete Double Component
I found the solution myself. The position of each component can be read/write in the panel . One of them was on position -800,100. I changed it into 100,100 and now you see them both.
Jan
Jan