Timming issues Flowcode to target 16F684

[Collimare]

I have downloaded the following code into the target and I have a programmed LED 1 second on time that is 5 - 6 seconds at the target.

What do I need to do to to get them to equal. Thanks, Howard

[DavidA]

please see this post by medelec, it gives some good advice on clock settings:

If you are still struggling post back.

http://www.matrixmultimedia.com/mmforum ... =26&t=6936

[Enamul]

Hi Collimare,
You have to use 19.66MHz crystal for the attached program but if you want to use other than that..you have to change that in Build>General options tab>Clock speed and also in Configure Chip you have to set correspondingly.

I have attached here a picture of configure...
Enamul