EB063 RF Tune

[MM3001]

Hello,

I was wondering if anyone knew the best way to tune the EB063 boards

TX & RX

I don't know where to start with the settings

Thank you

[JohnCrow]

Hi
The boards are fixed to the 433 868 or 915 MHz bands
The properties dialog let you move the frequency a small amout (430.2425 to 439.7550) MHz for example with the 433 Board.
This is done by moving the slider.

Both Rx and Tx need to be set to the same frequency to work correctly.
Ive attched a simple half duplex Tranceiver flowchart.

Just load this into both systems

EB063-Keypad Half Duplex Transciever.fcf

Half Duplex Tcvr

(12.5 KiB) Downloaded 473 times

Pressing a key on one system will show on the LCD on the other system.

They wont both transmit at the same time though.

The boards only work with the professional version of flowcode

You can sign up for access to the full support forums here

http://www.matrixmultimedia.com/mmforum ... =46&t=9958

[JohnCrow]

This is a simpler set up.

One system is just transmit and the other is just receive

EB063-Keypad Rx.fcf

Receiver

(11 KiB) Downloaded 547 times

EB063-Keypad Tx.fcf

Transmit

(11.5 KiB) Downloaded 514 times

[MM3001]

Thanks for the reply John

The keypad files that you have posted have proven to be very useful as I have previously looked at them, a good source of info.

I think that maybe I should have worded my initial post a little bit better as I was referring to the Tx & Rx_tune component macros in flowcode.
On the programme I am working on Noise seems to be an issue

If you could help with my issue it would be greatly appreciated

Thank you