Working on 4 x 7 segment display and no matter if I set dp to 0 or 1 or true or false, it is always lit on all digits.
Where am I going wrong..??
dp always lit in simulation
Moderator: Benj
-
bluejetsthree
- Flowcode v5 User
- Posts: 17
- Joined: Mon Sep 16, 2013 3:04 am
- Been thanked: 1 time
-
JohnCrow
- Valued Contributor
- Posts: 1367
- Joined: Wed Sep 19, 2007 1:21 pm
- Location: Lincolnshire
- Has thanked: 364 times
- Been thanked: 716 times
Re: dp always lit in simulation
Hi
Please post your flowchart so someone can have a look for you
Please post your flowchart so someone can have a look for you
1 in 10 people understand binary, the other one doesn't !
-
bluejetsthree
- Flowcode v5 User
- Posts: 17
- Joined: Mon Sep 16, 2013 3:04 am
- Been thanked: 1 time
Re: dp always lit in simulation
It's ok...I worked it out......
Need to connect the dp in connections first and then need to either set it to a 1 or 0 in the macro.
This then leads to another question....... what if I don't want to use the dp but need the pin for another purpose........is it possible or not..??
Thanks
p.s not much to the code so far, just have the display and trying to get it to work.
Seems instructions from previous versions are all different so gets a bit confusing.
Need to connect the dp in connections first and then need to either set it to a 1 or 0 in the macro.
This then leads to another question....... what if I don't want to use the dp but need the pin for another purpose........is it possible or not..??
Thanks
p.s not much to the code so far, just have the display and trying to get it to work.
Seems instructions from previous versions are all different so gets a bit confusing.