Bad installation of FC6?

[Chris_MIRA]

Hi,
Last week I did the upgrade from FC 6.1.0 to 6.1.1
Since then, I have had a problem in that any programme I down load to the micro hardware (e.g. EB006) now reads an analogue input of up to 5 volts with the wrong value, for instance I only get a read value of 128 for 5volts measured input. I have checked this by using the same programme on the same hardware but flashed using a different computer and different licence (FC 6.1.0). Ive cross checked all the relevant settings and they seem to be identical on both machines (programme attached
Please help, is there a setting Im not aware of? or do I need to revert to 6.1.0? If so how?
Regards,
Chris

[Chris_MIRA]

Forgot to add in the original message, values etc work okay in simulation but using ghost gives the hardware readings which are the faulty ones...

[LeighM]

Hi Chris,

Looks like a recent fix for 16F726 has broken 16F1937
Please try the attached CAL file (into Flowcode\CAL\PIC)

Thanks
Leigh

[Chris_MIRA]

That works! Thanks for the quick reply
Regards,
Chris