Dear Matrix Multimedia
Apart from the ECIO with its USB programming interface, are you going to offer any USB support in Flowcode for the USB enabled PICs so we can send data to/from the running code via the USB? I looked at some previous messages, and you were recommending use of RS232 and FTDI chips for communication.
Flowcode USB support
-
Steve
- Matrix Staff
- Posts: 3433
- Joined: Tue Jan 03, 2006 3:59 pm
- Has thanked: 114 times
- Been thanked: 422 times
It's something we've considered, but there are so many different types of USB communications that it's difficult to cater for every requirement.
Also, a lot of USB comms needs an equivalent driver on the Windows side of things. And different drivers are required for different USB protocols.
Do you have any specific requirements?
Also, a lot of USB comms needs an equivalent driver on the Windows side of things. And different drivers are required for different USB protocols.
Do you have any specific requirements?
-
reiner stockfisch
- Posts: 3
- Joined: Wed Nov 16, 2005 12:10 pm
- Location: Germany
USB support in flowcode
hi steve,
it would be perfect to have a tool similar to ecio. My specific requirements would be:
PIC 18F2255 or PIC 18F4455
driver for Windows XP prof.
DLL or code examples Visual basic 6.0 or Delphi 7 or MS C
COM 1/2
USB 1.0 driver
Do you think this could be considered ?
it would be perfect to have a tool similar to ecio. My specific requirements would be:
PIC 18F2255 or PIC 18F4455
driver for Windows XP prof.
DLL or code examples Visual basic 6.0 or Delphi 7 or MS C
COM 1/2
USB 1.0 driver
Do you think this could be considered ?
