To get gLCD working

[Nasim Khaliqhey]

sorry what do you mean ?
this small project is for a few LEDs to switch on & off what I have mentioned in very simple way .
that the output voltage in my personal project No;15: I don´t receive voltage with strong enough current to switch ON LED or a NPN transistor.
I did make circuits by using NE555 and CD417 ICs . & I know how to design synchronous counter by using IC s 74247 ,74193,+ Ne555 ect,
but unfortunately I don´t know PIC very much there for I need help to understand with out being humiliated .
wr
Nasim

[QMESAR]

Huh ?? I am schocked

After all these discussion about programming and various SW tools to program we are back at the original problem ,

Read the posts in this thread and you will see all the information Ben and people gave you to switch on a LED from a mcu pin
wow sorry for being rude but you should start to listen and and do what people tell you to do and help yourself nobody has the time to feed you like a baby with a spoon and after 30 post start at post 1 again the initial problem .
! Advise maybe you get an experience person and pay him money to do the project for you or pay him to train you the very basics of electronics and micro controllers and its nothing to do about PIC, it is about basic electronics and you will have the same issue with any other micro controller

when Ben and all the helping guys here, try to help you, they ask you for something "in east", your answer, is in the west, or you start a new question, no meaning.
Try to do and follow what our helping friends advice you to do, and one thing at the time. Otherwise it is difficult to help you.

I can only agree with Jurgen
you never answer the question people ask you ,you never show the results or the errors you see.How do you expect people to understand what problem you have this tread started out about get LCD to work ,then we discussed switching a lRD with a transistor from PIC pin ,then people corrected your Flowchart ,then we had a number of post regarding that the programming SW does not work we went from DATAMAN to PPP and then mLooder and now we back at the blinking LED problem

[Nasim Khaliqhey]

hey Mr Jorg.
I have done what I was inform with and only thing was not working was the programmer which is 80% ok now, every learner is like a baby hungry for information
I said many times for one subject of getting programmer working even if I can make in appointment with some one whom can fed knowledge to a learner
I would have taken a trip to England
It is not necessary now I will find out how to accomplish what is left with programming software .
Nice to know you
Nasim

[Benj]

Hello,

sorry to say that Spatchcock is a new Technical word for me do you mean a (coil) ?

Just trying to point out how hard it is to offer support in response to what you're saying.

As pointed out by the others you jump from problem to problem without ever getting anything resolved and without answering the questions that have been asked of you.

If English isn't your first language or you are not too familiar with it then please post in your own language and we will use Google translate to try and provide a better solution so you can proceed with your learning without everyone getting frustrated along the way.

I suggest we close this topic and if you encounter a problem then you create a new forum topic specific to the problem you are facing.

[Nasim Khaliqhey]

thanks allot
for the time being please close all communications we had so for
may be there has been some problems
but I have been using English in my communications with many companies
we find out about our problems when I reopen the Matrix user forums again.
with regards
Nasim

[Nasim Khaliqhey]

KEEP THIS ADVISE FOR YOUR OWN USE
THAN YOU.