Page 1 of 1
16f1938 port output masking inop
Posted: Sun Apr 22, 2012 9:39 pm
by brandonb
as title states when initializing unused inputs they dont respond to output port masking
Re: 16f1938 port output masking inop
Posted: Wed Jul 18, 2012 7:31 pm
by Enamul
Hi,
I can't understand what did you want to mean ? Can u tell bit more detail?
Re: 16f1938 port output masking inop
Posted: Fri Jul 20, 2012 5:59 am
by brandonb
I can't understand what did you want to mean ? Can u tell bit more detail?
the problems is, when the program first starts i like to initialize unused pins high, so i use output masking with the output icon, this is what fails, when i mask the bank pins they dont go high,..... have to command all unused pins one by one to make them have the correct output state on this chip
Re: 16f1938 port output masking inop
Posted: Fri Jul 20, 2012 9:32 am
by Benj
Hi Brandon,
Please can you post a program that demonstrates the issue and we will look into it for you.
Re: 16f1938 port output masking inop
Posted: Fri Jul 20, 2012 2:32 pm
by Enamul
Hi Brandonb,
I have tried to replicate the situation you have described but didn't get that...I am attaching here a FC. Can you have a look and tell is that the condition you are talking about and which you are getting problem?
At the same time you please have a look at the post for minor fix if you have not done already...
http://www.matrixmultimedia.com/mmforum ... 46&t=10669
Thanks,
Enamul