Page 1 of 1

Setting UART channel to use with Zigbee module

Posted: Sat Dec 08, 2012 9:22 am
by Sefi
Morning all,

How do you set the UART channel to use with the Zigbee module? Looking at the Ext Properties of the module I can't see where one would choose the UART channel.

many thanks
Sefi

Re: Setting UART channel to use with Zigbee module

Posted: Sat Dec 08, 2012 10:56 am
by Sefi
Worked out how to do it. Please ignore.

It involves changing or customising the code. It would be nice to have this as a menu item. Maybe MM will add this to the wish list.

Re: Setting UART channel to use with Zigbee module

Posted: Sat Dec 08, 2012 1:26 pm
by Sefi
The solution is fairly easy within FCv4.0 but in V5 with the addition of the CAL layer I can't work out where this should be done. So if anyone can help I'd be grateful.

many thanks
Sefi