Hello everyone.
I need to make a few programs for school, but i have a problem with the E-blocks.
I have the E-blocks EB-006 en installed flowcode 5. The problem is that flowcode tel me that the "USB cable is not connected" when i want chipconfigurate en thats the reason that i cant run a program on the E-block.
I have tried "http://www.matrixmultimedia.com/support ... cted#p1140" this forum, but the e-blocks not in the list on my computer.
Can someone help me please? Sorry for the bad englisch language.
thanks.
ERROR "usb cable not connected"
Moderator: Benj
-
kersing
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
Re: ERROR "usb cable not connected"
Are there any unknown devices listed? Have you installed the EB006 drivers? What revision of the EB006 are you using? (Revision is something like EB-006-00-X, it's next to port C on the hardware on the board sitting in front of me)
If you want to continue in dutch feel free to send a personal message (just click the PM icon on the right of this message)
If you want to continue in dutch feel free to send a personal message (just click the PM icon on the right of this message)
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis