Page 1 of 1
Unable to program using Mloader
Posted: Fri Jul 29, 2016 1:04 am
by Zane
Using Mloader and trying to program a PIC18F26K80 i get the following message
- Untitled.jpg (51.84 KiB) Viewed 4084 times
.
Using a PIC16F88 and it works ok.
Re: Unable to program using Mloader
Posted: Fri Jul 29, 2016 2:06 pm
by Steve
mLoader does not support the k80 at the moment and I cannot test it here because I do not have any of those chips, but I have tried to guess the fix...
If you use the attached files instead of the ones in the mLoader directory then it might work, but I cannot guarantee it.
If you do try, please make a copy of the original files and also let me know how you get on. If it works, we will add the files to the next update of Flowcode.
Re: Unable to program using Mloader
Posted: Sun Jul 31, 2016 5:03 am
by Zane
Hi Steve,
I have transferred over the files and tried programming the chip but get this message now.
- Untitled.jpg (15.53 KiB) Viewed 4048 times
There is no rush for this , its something i found and thought i would let you know.