ECIO28P & ECIO40P

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

Post Reply
Steve001
Valued Contributor
Valued Contributor
Posts: 1189
Joined: Wed Dec 31, 2008 3:37 pm
Has thanked: 460 times
Been thanked: 523 times

ECIO28P & ECIO40P

Post by Steve001 »

Evening All

is there a clearer diagram for the ecio modules?

Downloaded a product data sheet ref ECIO-60-2 and the diagrams are not very clear can zoom to around 150 % ish and the text is a bit better but still hard to read

Steve
Success always occurs in private and failure in full view.
Top
User avatar
LeighM
Matrix Staff
Posts: 2178
Joined: Tue Jan 17, 2012 10:07 am
Has thanked: 481 times
Been thanked: 699 times

Re: ECIO28P & ECIO40P

Post by LeighM »

Hi Steve,
As I recall, the pinout is available on the Chip view for the target in Flowcode, if that helps.
Not that I can check at the moment, not on this tablet, yet :)
Top
User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:
Contact Benj

Re: ECIO28P & ECIO40P

Post by Benj »

This datasheet shows the chips a bit clearer.
ECIO-60-4.pdf
(2.14 MiB) Downloaded 477 times
Top
Steve001
Valued Contributor
Valued Contributor
Posts: 1189
Joined: Wed Dec 31, 2008 3:37 pm
Has thanked: 460 times
Been thanked: 523 times

Re: ECIO28P & ECIO40P

Post by Steve001 »

cheers Ben

Leigh forgot about that option

Steve
Success always occurs in private and failure in full view.
Top
Post Reply

Return to “E-blocks”