Page 1 of 1
MPU9250 9-axis sensors
Posted: Thu Nov 08, 2018 9:02 am
by stefan.erni
Hi Ben
The Component MPU9250 is comfortabel to use with FC8.
The small problem is that I have to select I2C channel nr 5, every time I load my program to FC8.
That gives no error. But the program in the PIC will then hang on the part of the sensor.
where does the problem come from? From the Component or PIC32mz definition?
Re: MPU9250 9-axis sensors
Posted: Thu Nov 08, 2018 2:48 pm
by Benj
Hello,
This should not be the case and so it sounds like a bug.
Let me try and replicate for you.
Re: MPU9250 9-axis sensors
Posted: Thu Nov 08, 2018 2:58 pm
by Benj
Replicated and fixed, new component should now be available via the update system.
Thanks for letting us know.
Re: MPU9250 9-axis sensors
Posted: Thu Nov 08, 2018 3:20 pm
by stefan.erni
Hi Ben
Very good. It's fine now. Thank you
Re: MPU9250 9-axis sensors
Posted: Mon Nov 19, 2018 10:21 am
by stefan.erni
Hi Ben
I made the update to FC8.1
Now the problem is back
For the FC8.1 i have to remove 8.0 and install 8.1
That should not matter.
Re: MPU9250 9-axis sensors
Posted: Mon Nov 19, 2018 10:45 am
by Benj
Hello,
Hmm that's odd it's still working fine for me using 8.1. The update system currently seems to be disabled for 8.1 so I'll see if we can get it back online so we can check which version of the component you have installed.
Re: MPU9250 9-axis sensors
Posted: Mon Nov 19, 2018 10:51 am
by stefan.erni
Hi Ben
The patch is not working on a win7 computer and on a win10 computer
I made the update to FC8.1
For the FC8.1 i have to remove 8.0 and install 8.1
That should not matter.
But I am not sure that there is the right version. Various problems are back. These were ok before.
-The uart from the Pic32 is wrong (again)
-The mpu9250 is wrong (again)
-Grove Display I'm not shure what happen...
But scada is very good to have...
Re: MPU9250 9-axis sensors
Posted: Tue Nov 20, 2018 10:33 am
by stefan.erni
Hi Ben
It's ok again. I received the few updates today.