When a component macro contains a breakpoint any flowchart using the component will pause simulation on that component macro call as if there was a breakpoint set in the flowchart itself. The source of the component is required to remove/disable the breakpoint.
As the component macro itself can not be single stepped this 'feature' does not add value (imho).
Breakpoint in component halts FC on comp. macro call
Moderator: Benj
Forum rules
Only bug reports will be considered here. General questions should not be posted in this forum.
Only bug reports will be considered here. General questions should not be posted in this forum.
-
kersing
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
Breakpoint in component halts FC on comp. macro call
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
JonnyW
- Posts: 1230
- Joined: Fri Oct 29, 2010 9:13 am
- Location: Matrix Multimedia Ltd
- Has thanked: 63 times
- Been thanked: 290 times
- Contact:
Re: Breakpoint in component halts FC on comp. macro call
I was hoping no-one would notice.
This will be sorted in the next release.
Jonny
This will be sorted in the next release.
Jonny