View source for Custom Interrupts - dsPIC/PIC24

<sidebar>Sidebar: What Is an Interrupt?</sidebar>
Here are a few examples for such interrupts using 16-bit PICmicro chips. To create interrupts that are not shown below you will have to refer to the device datasheet. Once the code has been placed into the custom interrupt properties dialog, the interrupt can be enabled and disabled like any of the standard Flowcode [[Interrupt Icon Properties|Interrupts]]. 
[[File:Gen_Custom Interrupts_dsPIC-PIC24_USART.png|right]]
 

'''USART receive''' - This can be nicely integrated with the Flowcode RS232 component. 

<font style="color:#FF0000">'''Target PIC Processor ( dsPIC30F2011 )'''

'''(Note: For other PIC devices you may have to refer to the device datasheet to obtain the correct code)'''</font>
 

'''USART receive'''

The Flowcode RS232 component can be used to set the Baud rate and configure the mode of operation, and the ReceiveRS232Char function can be used in the handler macro to read the data (clearing the interrupt).


'''Enable code:'''

<span style="color:#000080"> IEC0bits.U1RXIE = 1; //Enable USART receive interrupts </span>

 
'''Disable code:'''

<span style="color:#000080"> IEC0bits.U1RXIE = 0;  //Disable USART receive interrupts </span>

 
'''Handler code:'''

<font style="color:#000080">void _ISR _U1RXInterrupt(void) // U1RX Interrupt Handler Function

{

FCM_%n(); // Call Flowcode Macro

IFS0bits.U1RXIF = 0; // Clear Interrupt Flag - Rearm Interrupt

} </font>