API Panel.LinkBar.SetEndAdjustment

	SetEndAdjustment
Sets the clipping adjustments for the end of the link
- HANDLE	LinkBar
The handle to the bar to adjust the position of
- ULONG	Adjustment
The automatic adjustment mode for the end position
- FLOAT	Offset
Positive to move the end point towards the center of the link
- NONE	Return

Detailed description

This causes the link end to clip to an offset from the center of the end position.

The Adjustment is the clipping mode for the end of the link. This is the position the link will end when considering the bounding box of the end position. The default is Adjust_Box. Adjust_Sphere will assume a spherical area around the position, and Adjust_None will end the link at the center of the position. All modes may be adjusted by Offset.

Clipping modes

The Offset is always a positive value to reduce the length of the link. That is, Offset is from the end position in the direction of the start position. Specifying 10 units will reduce the link length by 10 world units.

Examples

Calling in a calculation

• Add to a calculation icon:

  ::Panel.LinkBar.SetEndAdjustment(linkbar, ::Panel.LinkBar.Adjust_None, offset)

No additional examples