Component: Gyroscope 3-Axis (L3G4200D) (Movement Orientation)

Author	Matrix TSL
Version	2.0
Category	Movement Orientation

Gyroscope 3-Axis (L3G4200D) component

Interface to the L3G4200D three axis digital gyroscope. Panel GUI can be used to simulate incoming data for testing.

Component Source Code

Please click here for the component source code: FC_Comp_Source_Gyroscope_L3G4200D.fcfx

Detailed description

No detailed description exists yet for this component

Examples

No additional examples

Macro reference

	GetZ
Returns the previously sampled Z axis data
- INT	Return

	GetY
Returns the previously sampled Y axis data
- INT	Return

	GetX
Returns the previously sampled X axis data
- INT	Return

	SampleDevice
Reads the Axis data from the device
- BYTE	Return

	ReadRegister
Read the data byte at the given address of the device
- BYTE	Reg
address of the register to be read
- BYTE	Return

	WriteRegister
Writes the data byte to the given address of the device. Returns 0 if successful
- BYTE	Reg
address of register to be written with data byte
- BYTE	Data
data byte to be written to device register
- BYTE	Return

	Initialise
Initialise the component.
- BYTE	Return

Property reference

	Properties
	Output Data Rate
	Full Scale Selection
Specifies the maximum angular speed which the sensor can measure in degrees per second
	X Axis
	Y Axis
	Z Axis
	Label
	Connection
	Channel
Channel selection
	SDA
Pin used for SDA (data signal)
	SCL
Pin used for SCL (clock signal)
	Baud Select
Baud rate option selector
	Baud Rate
Baud rate to be used
	Stop Delay
On older microcontroller devices there is a potential for the I2C hardware channel to lock up if there is not a 10ms delay between an I2C stop event and the next I2C start event. Most modern microcontrollers will not have a problem so this property can be disabled to speed up the I2C communications.
	Simulation
	Simulate Comms