Component: DALI Master (Comms: System)

Author	MatrixTSL
Version	1.0
Category	Comms: System

DALI Master component

A serial based communications protocol designed for controlling lighting, specifically digitally controlled dimmable fluorescent ballasts. DALI requires the signals to be level shifted from VCC and GND to +9.5V - +25.5V and GND. The master component can addess up to 64 individual slaves & up to 16 groups.

Detailed description

No detailed description exists yet for this component

Examples

DALI Master Example, reads the value of a keypad and sends out DALI commands based on the key pressed, 1 = switch on a slave's light, 2 = switch off a slave's light, 3 = read the slave's light level. DALI Master Example1 DALI Slave Example, listens for DALI messages and checks that the group is correct before attempting to process the request and if required reply to the master. DALI Slave Example1

Downloadable macro reference

	ReceiveBackwardFrame
Attempts to receive an 8-bit reply 0 indicates timeout or no reply
- BYTE	Return

	TransmitForwardFrame
Send out a 16-bit frame consisting of the 8-bit address and data bytes. After sending the controller will attempt to receive If a reply is detected then the Return value will equal to the reply. If no reply is detected then the Return value will be 0.
- BYTE	Address
Address byte
- BYTE	Data
Data Byte
- BYTE	Return

	TransmitIndividualForwardFrame
Sends out an individual frame containing address and data. After sending the controller will attempt to receive a reply. If a reply is detected then the Return value will equal to the reply. If no reply is detected then the Return value will be 0.
- BYTE	Address
Individual Address 0-63
- BYTE	Type
0 = Data, 1 = Command
- BYTE	Data
- BYTE	Return

	TransmitGroupForwardFrame
Sends out a group frame containing address and data. After sending the controller will attempt to receive a reply. If a reply is detected then the Return value will equal to the reply. If no reply is detected then the Return value will be 0.
- BYTE	Address
Group Address 0-15
- BYTE	Type
0 = Data, 1 = Command
- BYTE	Data
- BYTE	Return

	Initialise
Configures the UART serial interface.
- VOID	Return

Property reference

	Properties
	TX Pin
	RX Pin
	Connections
	Simulations
	API