Hi, I was programming an Arduino Uno with code that I had previously used without any problems. But, when I needed to program a few more boards with this code I got an error message which I have attached stating a 820: error "Unkown or missing port variable: PORTA.0 " The Flowcode version I was runn...

Hi, I am trying to set up an Arduino UNO R3 smd board to read a pot and output that value to a DAC. I am using a Micro shield board with a DAC 2 click in the position 1 slot. The circuit does not work at all and I don't seem to have a clock or cs pulse. When I simulate the circuit it seems to work f...

Hi Martin, Thanks for your fast response. I am not in the lab until next week so I will not be able to test the circuit until then. However, I have written a small program at home and tested the analogue inputs using the suggestions you made and it works fine, so I have confidence in the changes wor...

Hi, I have written a program using the Arduino Uno R3 smd version and FC9. It simulates perfectly but when I connect the Arduino in circuit it does not seem to respond to the analogue inputs at all. For example I can o/c all the analogue inputs and the program runs through the "Start up Macro" and o...

Hi, I have a project which requires connection to a vehicle CAN bus and to look for a "Ign ON" status to trigger a response from my circuit.This is my first time using CAN and I am not sure how to set this up. It is a 8 byte message in hex ( 17F00010 ) and I wondered if anyone had an example I could...

Hi Steve,
Thanks for your response.
I have attached the message files but, I don't see the files you speak about.
Mark

I have just programmed a BL061 board and was able to use the Ghost ICT ok, but when I tried to use the ICD an error 0x1 occurred.
I am using the latest flowcode 9 version and I have attached a screenshot of the error code seen.
Could you help me sort this problem please.
Thanks

I am trying to set the frequency of a PWM signal to 100Hz and the closest I can manage is 122Hz. Do you have any examples to demonstrate how I might be able to achieve this? I have attached a screenshot for reference.

Hi Steve, I downloaded Flowcode V9 from the website this morning and was able to carry out the updates without any issues.

Hi Steve, I have tried your suggestions but Flowcode still failed to update. I also uninstalled and reinstalled but the outcome was the same. I have now installed Flowcode v9.0 which works OK until you have a solution. But I would like to be able to update to v9.1 as soon as it is possible. Thanks M...