Hi

Legend all sorted thank you very much for your time

Thanks again

Hi

Thanks for your recent post I have resolved the issue I had it is now working as I need it.

Thanks for your help

Hi I have updated files as you suggested and noted that the mechatronics pack does not have a red x. I have modified the motor to pins Port B1 and Port B2 the programme now compiles but the hardware i.e the motor does not respond. I have sent a photo of the set up in which the BL0127 board ic connec...

Hi Thanks for your help, Whilst the simulation operates ok I have the same issue in that the output D0 is always on regardless of light condition. I have the following set up. EBLOCKS 2 Grove board BL0129-1 connected to a grove light sensor. I have set the channel input to An0 as the grove board is ...

Hi

I am using BL0011 progammer and trying to switch an output on and off depending on light conditions. The programme downloads and switches on the LED but does not switch off if I cover the sensor to simulate darkness. I have attached the file

Can you please help

Nev

Hi I am using BL0011 programmer and trying to run the DC motor on the E-Blocks 2 board 0127. I need the motor to start forwards for 5 seconds and then stop for 5 seconds and then reverse. Whilst the simulation runs correctly to a degree it is returning an error when downloading to the micro. Can you...