Hi Martin
I will try it on a home PC to make sure

Pete

Hi Martin
under locations in PIC it ends with picv2 does this mean I have the 8 bit tool chain installed?

Pete

Good Morning Martin
thank you for the quick response. It is now getting further but mloader is saying there is no device detected. I am guessing that despite me asking for the compilers maybe the appropriate toolchain has not been installed by IT here, could you please confirm.
Pete

Hi All I have the above board along with various original E blocks. I would like to set it up but when I choose new project I cannot see an obvious target to set it to.

Could someone please help.

Many thanks

Pete

correction the motor is now running thank you can you please explain what I did wrong

Hi Martin
I have updated flowcode reprogrammed the arduino but still the motor does not turn. I also did not get a compiler warning. I am sure there is something simple I am doing wrong?

Pete

Hi Martin
I have A connected, channel6 selected, Port shows as $PORTD.3 but is greyed out and the direction pin is $PORTB.4

I have 250 for speed 300 for acceleration and 50 for deceleration

unfortunately it is still not working

Pete

Thanks for the quick response Martin. I assume once I install the file, as I have I just need to program the arduino with the file I put on the posting. If so its still not working.

Hi I am having issues setting up an arduino motor shield in conjunction with an arduino uno R3. I suspect I have some wrong pin assignments, but havent worked it out and couldn't find any help for it. I have attached my very simple program can someone please point me in the right direction.

Pete

thank you Martin that worked a treat it now works