Thanks Martin,

I had figured it out with shifts just as you had posted, although slightly different to the way you have explained. I will try your way too.

Now for all the calcs then to re-assemble.

thanks again,
Mick

Hi all, I'm trying to combine 3 bytes of data to manipulate and forward over CAN to 4 bytes of data the reasoning behind this is device A calculates it's data different to device B, I'm developing a gateway to go between device A & B. E.g. B0=f8, B1=ff, B2=ff Combined = fffff8, how do I do this ...

Thanks for the info Steve, all works, very much appreciated.

Hi All,

I'm wondering if you could add PIC 18f45k20 44pin to your list of devices, currently only the 40 pin device available.

Thanks,
Mick

Hi Stefan, It makes no difference if it is Open GL Hardware or Software and it only seems to be with the 2d panel, even in a new project without anything in it. If I use 3d panel all is ok. The issue is I can't select the individual component properties like CAN and SPI, these do not show on 3D pane...

Hi all, I am all of a sudden having an issue with FC9. When I open the 2d dash panel it opens, doesn't load the components then FC shuts down completely. I can do everything else in FC when 2d panel is closed. I have deleted everything FC and re-installed but issue is still there, PC is win11 which ...

Thanks Steve,

all works fine now

Hi All, having an issue with FC9 activation, I note my username isn't my username for FC9 on my account page, it's just numbers when I try to activate the license key it says its already been used Looking at the show key, it shows nothing and if i click get key file the flowcode site times out the a...