Hi

As I can download OK from within FC (albeit by pressing reset) I never looked at mLoader but good suggestion. I might try that too just to see, well after the Rioja....

Regards

Hi I don't see any com port appear at all in W7. I might try W8.1 later tonight, but as I'm staring at a nice Rioja at present, probably not <s> Whilst plugged in, does the led flash if the reset button is pushed (as per Martin's reply)? If so then you can probably compile to chip. Make up a little ...

Hi I got one of those last year. Not had time to play with it really. On my W7 laptop I installed drivers but although the laptop made the "connection" noise soon after it was plugged in, it then made the "disconnect" pretty much straight after and at no time can I see anything under device manager....

Hi I've only recently started playing with an Uno, mainly to explore Flowcode Developer, so I'm no expert with it. Keen to play I downloaded your chart (and Martin's component). Whilst I don't have the motor shield I can monitor the pins with a logic analyser. No matter what I tried I couldn't get a...

Hi

Fonctionne bien avec mon EB006-v8.
Je ne peux pas dire avec certitude à propos de la v7. Peut-être télécharger une version d'essai gratuite de FC9 ?

Works fine with my EB006-v8.
Can't say for certain about v7. Maybe download free FC9 trial?

Regards

Hi

I use Terminal, another free offering. It's a bit old but has many features I find useful (https://sites.google.com/site/terminalbpp/).

Regards

Hi Still traveling, back at weekend so maybe then I'll have time to look at your chart. From searching around I have seen reports that the BME280 can take a bit of time to settle before accurate readings can be obtained. Maybe you could experiment a bit using only the component? That may help to nar...

Hi Sorry I cant be of better help as I'm travelling and this laptop doesn't have FC on it, so I can't look at your project just yet. I don't have much experience with the ESP32 (but recently purchased one) so I am no expert. From the brief outline of your project it sounds like something I'd look to...

Hi Sorry to be brief. In Config you have selected HS-Osc as your clock source, and have PLL enabled. What crystal are you using? From memory (as I don't have the datasheet to hand) the PLL will only multiply either the 8MHz internal Osc or the External Osc (which you have selected) up to a maximum s...

Hi Not sure if I understand your request correctly. Do you wish to connect a button for example between Port A0 and B0 or such like? If so, how will the ports detect any change in voltage? Will you initially make Port A0 "high" and try and detect a "high" on Port B0? If so you could just set B0 to b...