Stefan. When I was in Swiss, I always worked with Roland Ruetimann Microchip( FAE ) he will visit you and get you a line of supply at better prices direct from Microchip as you are not a hobyist but a developer you will get much better prices and you own direct line of supply contact him he is close...

Stefan,

you should order from Microchip direct online shop from the microchip website

Hi,
Looking at the datasheet C15 is also the CLK0 pin therefore I would expect that you need to run the corrcet settings and Oscilltor to beable to use C15 as an IO pin
just saying

Hi,

I havent check the datasheet and it a long time since I last worked with a 6014 but as I recall it could be that pin is a open drain pin so then you need to connect it ot some sort of source ,just check the pin specs again

HI,

Just a quick question do you have pull resistors fitted to the SDA and SCL lines ?

Hi What you see is normal FC/Compiler will not generate a hex file if there is an error in the code, You have an error in the way you are parsing the strings (I would think you should use a loop do that) anycase the problem is that your C code generates an error and therefore the hex file is not gen...

Hi

Why do you want to reinstall FC9 ,what Hardware are you using a custom build or an Arduino board?
Go to Build Project options as below

Then theconfiguration window opens you have to set the Configuration of the Mega to suit your hardware configuration

Hi,

Running your flowchard on a Adruino Mega2560 the code is working fine ,I susspect your Configuration settings for your mega is not set correctly as Steve indicated above

Hi, Normaly the Slave are connected to your sensors by he normal mcu peripherals (ADC.I2C,SPI .etc) the slave then can connect to the MODBUS Master which could be another mcu or a PC ,the connection is done by UART conforming to RS232 or RS485 it could also be a MODBUS TCP connection i.a.w an LAN or...

Hi

I might be wrong however I still have the view Interrupts are not supported in Simulation