Hi Martin,

I was just checking, the board i have here is set to 3 turns. I can de-solder the sensor and re place it on the board so 1 turn


Regards
Steve

Afternoon All,

Was just having a nosey at this because it pricked my interest a while ago

Can the component cope with the tapping changes ? i.e 1 turn through the device, 2 turns, 3 turns ?

Cannot see how to do this

Steve

Hi Martin Thank you It might be a good idea to wire a smoke detector to a relay that cuts the power to items being soak tested? This is something we have at work in the Test Area's - never thought i would need it at home - but definitely worth a thought I have a separate supply to my bench sockets t...

hi Jorgen, To be honest its something i never gave a second thought to either, have left all sorts switched on on a soak test unattended. It was on for about 2 hours before it failed it wasn't instantly. Just probably unlucky with a rouge supplier from china - some choice words came out later to des...

Afternoon All,

Dose the Ethernet module support ASCII Protocol commands ? commonly used it Automated Test Equipment

2 examples of commands attched

Steve

Morning All Thought i would share my experiences with one of these items -. I purchased 2 of these some time ago, and decided to get them out again to try and finish a clock project that i have been working on for some time. After compiling a simple test flow chart, i decided to leave my project run...

Hi Wingnut I have used Euro Circuits before with work for some prototypes they make a good quality PCB. Not the cheapest but you do get what you pay for. As Chip Fryer says watch for carriage and import taxes. PCB Train is also another good manufacture and they have a good online calculator Electric...

Cheers Ben

Bit Confused if somebody can point me in the right direction please looking on the tinterweb gives this information selecting Nano 322 as my target device When mapping port pins flowcode shows the actual device not the nano Screenshot 2021-11-19 152049.png how do i know which pin is which ? - or am ...

thank guy's Got the driver shows up as in device manager Com Port.JPG not sure what target to pic ? target.JPG is it the Duemilanove 328P ? and The only thing different you need to do when using Arduinos from say PICs is to set the COM port to the device within the project options. can you explain a...