You also need to call Refresh after doing the setall - to upload the data to the leds

C:\ProgramData\MatrixTSL\FlowcodeV9\CAL\ESP\ESP_CAL_RMT.c:112:19: error: conflicting types for 'FC_CAL_RMT_TX_1'
CALFUNCTION(void, FC_CAL_RMT_TX_, (void))

Definitely trying to include the esp code?

If the target is a 328p then there is an issue with the component?

Martin

This is an issue with ESP32 and later versions of the RMT interface.

See the post at viewtopic.php?p=14339#p14339

For a working version - the RMT interface and to have changed dramatically...

Martin

If you post your chart - someone will surely be able to help...

Martin

I had a bit of a play with 5.2 - but although I could compile from the command line couldn't get it to work from within FC.

So went back to 5.1.2. Which seems to work AOK..

Martin

Ok - I'll replace the spaces with commas - odd that it works for the original data block - which also uses spaces....

Yes - a table of 8 bit values.
Not sure if size is limited but the initial size shows correctly and in simulation (which is all that is needed here) seems to work correctly (although I didn't single step through it all - and the simulation locked when I altered the rate slider)

Martin

I hit a small issue resizing a lookup table (in an Arduino sketch - though this might not be relevant) I created an 8 bit lookup table and pasted in 4637 values - this was correctly reflected in the num values field. However - to create a simpler 'demo' version of my program I then replaced these va...

A version that allows multiple 'message blocks' to be read:

Here allowing MIDs of 128 and 144.

Yes, and no.

It actually stores a 16bit sum - the twos complement of this (% 256) needs to be 0.

Martin