Hi
Not actually done this and at present I've no real access to ESP32's until I sort a few things out, so I have no idea if it will work.
The ESP32, like the ESP8266 can be controlled via "AT" commands and a lot of changes are retained. Perhaps you could change using "AT" then use FC as before?
I probably have the AT command set somewhere so I will see if it allows such. Again I've no idea if this is feasible or just stupid
Regards
ESP Hostname Change
-
- Valued Contributor
- Posts: 1281
- http://meble-kuchenne.info.pl
- Joined: Thu Dec 03, 2020 10:57 am
- Has thanked: 312 times
- Been thanked: 452 times
-
- Posts: 177
- Joined: Thu Sep 23, 2021 3:44 pm
- Location: France
- Has thanked: 31 times
- Been thanked: 22 times
Re: ESP Hostname Change
You can try with this prog, it's for TTGo but you can change the Target device need to change SSID and PW then compilechipfryer27 wrote: ↑Thu Dec 14, 2023 5:12 pmHi
Not actually done this and at present I've no real access to ESP32's until I sort a few things out, so I have no idea if it will work.
The ESP32, like the ESP8266 can be controlled via "AT" commands and a lot of changes are retained. Perhaps you could change using "AT" then use FC as before?
I probably have the AT command set somewhere so I will see if it allows such. Again I've no idea if this is feasible or just stupid
Regards
wait for the connection to router and look the IP address of you ESP32
then you can open webpage and type the IP address of your esp32
Seb
-
- Valued Contributor
- Posts: 1281
- Joined: Thu Dec 03, 2020 10:57 am
- Has thanked: 312 times
- Been thanked: 452 times
Re: ESP Hostname Change
Hi
Section 4.2.14 (page 26) of the ESP32 AT Command set informs that you can indeed change the hostname by issuing
AT+CWHOSTNAME=<hostname>
However as this is one command that isn't saved in Flash the point is moot.
Sorry, looks like you need some C or other edit.
Regards
Section 4.2.14 (page 26) of the ESP32 AT Command set informs that you can indeed change the hostname by issuing
AT+CWHOSTNAME=<hostname>
However as this is one command that isn't saved in Flash the point is moot.
Sorry, looks like you need some C or other edit.
Regards