atmega 2560 flowcode9 does not work

[d820513]

today switched to atmega 2560, uploaded blink, but it doesn't work via flowcode

[Steve-Matrix]

Is this an issue with simulation or downloaded code, or both?

[d820513]

uploaded blink

[Steve-Matrix]

Are the configuration options in "Build..Project Options" appropriate for your hardware? Specifically the clock source.

[d820513]

yes, I checked it several times

[p.erasmus]

Hi,

Running your flowchard on a Adruino Mega2560 the code is working fine ,I susspect your Configuration settings for your mega is not set correctly as Steve indicated above

[d820513]

where can i see the settings? can i reinstall flowcode9

[p.erasmus]

Hi

Why do you want to reinstall FC9 ,what Hardware are you using a custom build or an Arduino board?
Go to Build Project options as below

P1.JPG (51.49 KiB) Viewed 1783 times

Then theconfiguration window opens you have to set the Configuration of the Mega to suit your hardware configuration

P2.JPG (99.04 KiB) Viewed 1783 times

[d820513]

ok i will do as you said

[d820513]

look