File from flowcode 4 to open with v9

[medelec35]

hello
Attached should open in v9 and v10, but you will have some work to do.

[chipfryer27]

Hi

Following on from the above posts, I think you would be better off recreating your chart in v10 and perhaps also consider using the HX711 component instead of reading the ADC. Much easier in my opinion and examples of using the component (including calibration) can be found in the wiki

https://www.flowcode.co.uk/wiki/index.p ... 1)_(Force)

Regards

[daddytims_tims]

Many many Thank for your time and patience Medelec35 for the Conversion of the project.


Thats a Good Idea @ Chipfryer . Thank a lot for that information (I didn't know about it until you showed me).
am going to work on it. in v10.