GPS

[ELECTRONICA67]

Hello, I would appreciate some help,

I am migrating programs that I have made from previous versions of flowcode, V5, V6, V7 to the new version 10, at this moment I am with a program that uses the GPS component, to read Latitude and Longitude; but I can't read the location, it sends me 0.000000 and 0.000000, I use the example and another program that I believe simplifies the example using new options offered by Flowcode 10.

I send the flowcharts of 2 examples that do not work for me.

Enrique
Thanks

[ELECTRONICA67]

imagen

[ELECTRONICA67]

After 3 hours one of the programs (TEST1939v10) could be connected, but with readings that constantly varied. . .

[ELECTRONICA67]

Yesterday, the circuit was connected and in 8 hours no satellite was connected.

[ELECTRONICA67]

The longitude is correct, the Latitude varies too much

[ELECTRONICA67]

I was using a socket for the GPS, I'm going to solder it directly to the PCB

[ELECTRONICA67]

The latitude continues to vary a lot, the longitude remains constant and correct, on average for every 10 readings, it sends a correct latitude

[ELECTRONICA67]

I think maybe the GPS component needs to be fixed.

I have installed and designed (Flowcode) a GPS in my car for more than 9 years and it works correctly and gives me the exact location of where it is.

[kersing]

Have you tested this hardware setup with the same software you used before?

[ELECTRONICA67]

Yes; I'm going to change the GPS to verify that it is not the fault.