The hardware does not run after downloading to the chip using port programming
-
- Posts: 85
- http://meble-kuchenne.info.pl
- Joined: Thu Jan 07, 2021 11:28 am
- Has thanked: 3 times
- Been thanked: 4 times
The hardware does not run after downloading to the chip using port programming
I use esp32_ WROOM_ 32 controls 4 LEDs, with control pins in the flowchart. After downloading to the chip, the hardware runs normally. However, if the port is controlled in the flowchart, the hardware does not run and the LED does not light up after downloading to the chip. Please help me take a look! Thank you!
- Attachments
-
- A06.png (138.88 KiB) Viewed 16740 times
-
- LED_PORT.fcfx
- (10.45 KiB) Downloaded 670 times
-
- LED_Pin.fcfx
- (10.45 KiB) Downloaded 700 times