Hello,
Happy New Year to everyone!
I tried the SHT-31 sensor on the Clicker2 panel.
The MCU type is PIC24FJ1024GB610.
If I select Channel 3 in the "Grove Component SHT31" Component Properties window, I get the attached error message from the compiler.
Regards,
Sasi
PIC24FJ1024GB610 I2C Channel3 problem
-
- Posts: 44
- http://meble-kuchenne.info.pl
- Joined: Wed Dec 02, 2020 12:11 pm
- Has thanked: 10 times
- Been thanked: 6 times
-
- Matrix Staff
- Posts: 1269
- Joined: Sat Dec 05, 2020 10:32 am
- Has thanked: 169 times
- Been thanked: 285 times
Re: PIC24FJ1024GB610 I2C Channel3 problem
It looks like there is an issue using Channel 3 for the I2C for this chip. If you change this to Channel 1 or 2 (or use software mode) then it should be ok.
Re: PIC24FJ1024GB610 I2C Channel3 problem
That's right.
There is only a problem with channel 3.
But I don't think it's a chip bug because I get an error message from the compiler about references to undeclared variables.
There is only a problem with channel 3.
But I don't think it's a chip bug because I get an error message from the compiler about references to undeclared variables.