time runs very fast
-
Vatel20
- Posts: 19
- http://meble-kuchenne.info.pl
- Joined: Wed Dec 16, 2020 10:07 am
time runs very fast
time runs very fast in the version 8 and version 9
- Attachments
-
- TestTimer.fcfx
- (13.03 KiB) Downloaded 435 times
-
p.erasmus
- Posts: 434
- Joined: Thu Dec 03, 2020 12:01 pm
- Location: Russia / Россия
- Has thanked: 104 times
- Been thanked: 88 times
Re: time runs very fast
Hi
When is it running to fast in simulation or Hardware
looking at your flowchart the Timer interrupt is set at a very fast rate may be you should do some adjustments
When is it running to fast in simulation or Hardware
looking at your flowchart the Timer interrupt is set at a very fast rate may be you should do some adjustments
- P1.jpg (58.41 KiB) Viewed 4398 times
Regards Peter - QME Electronics
Re: time runs very fast
Sorry I do not know how it happened. I send the correct setting. but the result is the same. What I understand is that every clock cycle interrupt.
- Attachments
-
- Int.png (21.9 KiB) Viewed 4373 times
-
medelec35
- Matrix Staff
- Posts: 1956
- Joined: Wed Dec 02, 2020 11:07 pm
- Has thanked: 626 times
- Been thanked: 657 times
Re: time runs very fast
It depends if you are referring to simulation or hardware.
If simulation then it will run fast and I can help you further with that.
If hardware then if you post your flowchart then I can see if I can help you further.
If simulation then it will run fast and I can help you further with that.
If hardware then if you post your flowchart then I can see if I can help you further.
Martin