Servo Component with ESP32

Any bugs you encounter with Flowcode should be discussed here.
Post Reply
dvcam99
Posts: 94
http://meble-kuchenne.info.pl
Joined: Fri Dec 04, 2020 11:03 am
Has thanked: 6 times
Been thanked: 12 times

Servo Component with ESP32

Post by dvcam99 »

Hello Ben,

I´m using the Servo Controller at a ESP32 controller. In general I have a question.

If I sent a servo set value of 32767 in 16Bit or 127 in 8Bit I would expect a servo center position of 1.5ms. In real controller life I´ll get
around 1.3ms. Unfortunately this ends up in a asymmetrical servo end positions too.

Servo Controller was set to 1ms and 2ms.

Below a scope picture, please watch for the red trace and the meas values:
esp32 servo pwm.png
esp32 servo pwm.png (52.67 KiB) Viewed 2176 times
Any chance to correct this situation?

BR

Dirk
Happy FC9, FC-8 and FC-6 professional user ;)

flowmaker
Posts: 2
Joined: Tue Mar 12, 2024 6:53 am

Re: Servo Component with ESP32

Post by flowmaker »

I have tried flowcode v10 free for makers, and when I tried to use the servo controller component in esp32 the results did not work properly. I have tried changing the minimum value to 400uS and maximum to 2400uS the results in the oscilloscope doubled.

Post Reply